Osha Flat Roof Fall Protection Requirements

Each employee on a steep roof with unprotected sides and edges 6 feet 1 8 m or more above lower levels shall be protected from falling by guardrail systems with toeboards safety net systems or personal fall arrest systems.

Osha flat roof fall protection requirements.

Lay headers sheets of roofing or other materials no closer than 5 feet inside the edges of the roof and parallel to the roofline. Subpart m 1926 501 b 10 of the osha construction standards specifies that under certain conditions roofing work can be conducted with a warning line in place 6 feet from the edge and a safety monitoring system. When the fall protection measures listed above are not used mark the edges of the flat roof with headers and warning lines to notify workers of potential fall hazard areas using the following guidelines. Fall protection systems and other equipment they will be using on the job.

If there is a fall risk it needs to be addressed. Less than 6 feet from the roof edge. Between 6 feet and 15 feet from the roof edge. Supervise workers to ensure fall.

Implement safe work practices to reduce the possibility of falls. Osha defines what fall protection is required based on how close employees are to the edge of the roof. Employers are to ensure. Understand the requirements of osha s fall protection standards at 29 cfr 1926 subpart m to protect workers exposed to falls six feet or more above a lower level.