Revision d 8 30 2011 1 0 otdr quick start guide press to turn on the otdr.
Otdr fiber tester manual.
4 2 connect the tester to the link as shown in figure 4.
September 2020 optical testing and monitoring.
Attach launch cable to otdr.
Watch now overcoming the challenges of testing dwdm channels.
Press to cycle through the wavelengths and choose the wavelength to be tested.
Optifiber pro hdr provides two pon test suites.
4 3 tap test or press.
Passive optical network pon testing.
To conduct a manual test if using the otdr as the light source perform reference procedure as above and place fiber under test in line between the reference cord and the power meter port.
The optical time domain reflectometer otdr provides an inside view of the fiber and can calculate fiber length attenuation breaks total return loss as well as splice connector and total losses.
In manual mode all the otdr parameters can be adjusted in the otdr setup menu.
If approximate fiber length is not known.
Chapter 11 fibercomplete modules saving results and generating a report note in unidir bidir modes the wavelengths selected for il orl are also used for otdr testing.
Auto pon otdr and manual pon otdr.
Clean all connectors and mating adapters.
Press to cycle to the desired wavelength the otdr will start a scan at the parameters displayed.
If set to auto once otdr sets range pulse width time and filter for the first test.
Attach receive cable if used to far end of cable.
The basics of fiber testing.
Ensure you are in menu mode and scroll to source soft key.
After test returns user to otdr home page in manual mode where user may change any setting for next tests.
Use the directional buttons to highlight the icon on the left side of the display.
Press to enter the menu mode.
The tester automatically uses the discover function to identify splitters.
With the rapid advancements in fiber optic technology otdr testing methods have become indispensable to building certifying maintaining and troubleshooting fiber optic systems.
Setup auto setup manual setup auto once if set to auto otdr sets range pulse width time and filter for each test.
Set up test parameters on otdr.
Passive optical lan testing.
Note to go from one tab to the other one press the r button or with touch.
Attach cable to test to end of launch cable.
Turn on otdr and allow time to warm up 2.
The otdr allows you to characterize a fiber optic span usually optical fiber sections joined by splices and connectors.
Do the otdr test 4 1 clean and inspect the connectors on the launch and tail cords and the fiber to be tested.
Attach receive cable if used to far end of cable.
